Make sure the rule name is selected in the drop-down list under path rules.Ĭlick OK. ![]() ![]() In this case, below we’ve added another rule to slow down the machine to 80% 5mm before and after a corner tighter than 90 degrees.Ĭlick OK. The rule will display in the list.Ĭontinue to add rules as you need them. Select ‘On small circles’ from the drop-down list.Īs below, we’ve set the feed rate to drop to 80% when cutting out circles that are smaller than 30mm in diameter.Ĭlick ok. In this instance, we’re going to slow down the movement when the machine in cutting out small circles. ![]() You can add a ruleset from the operation screen:Ĭlick the drop-down box at the top of the window and select ‘Add new rule set’ Cutting rules in SheetCAM are a powerful way to fine-tune your cutting results.
0 Comments
Leave a Reply. |